
5
Install Batteries
Note:
•
You can only use AC power as power
supply. Batteries ( not supplied ) are for
powering the clock and alarm only.
• Ifthesystemisunpluggedorifapower
failure occurs, all setups of the unit will be
erased unless there are batteries in the unit.
1 Open the batteries compartment.
2 Install two AAA batteries(not supplied) with
correct polarity as shown in the diagram
above.
3
Close the battery compartment.
Connect Power
Caution:
- Risk of product damage! Ensure that the
power supply voltage corresponds to the
voltage printed on the back or the underside
of the unit.
- Before connecting the AC power cord, ensure
you have completed all other connections.
Connect the AC power cord to the wall socket.
General Operation
Power
You can use all the functions onthe topofthe
unit or the remote control after connecting to
power supply (called Standby Mode).
Turn On
Press ON/OFF button to turn the system on from
standby mode.
Press ON/OFF/SOURCE to select dierent
functions.
When turning the system on, the unit will start
in the same mode as it was in when it was
switched off.
Turn O
Press and hold ON/OFF button on the unit or
press the button on the remote control again
to turn the system off and go to standby mode.
The unit will automatically revert to Standby
Mode when not in use for 15 minutes.
Be sure to unplug the power cord from the
outlet when the system is not in use for an
extended period of time.
Set Time
The built-in clock shows the correct time in the
display.
1 In standby mode, press and hold the CLOCK
button for some seconds, hour indicator will
blink.
2 Set the hour with the
button or
button.
3 Press the CLOCK button to conrm, minute
indicator will blink.
4 Repeat steps 2-3 to set the minutes, day,
month and year.
In standby mode, press and hold the CLOCK
button for 3
seconds, then press the
BF
butt
on t
o selec
t 12/24 hour f
or
mat.
Comentarios a estos manuales